WMR manual

This is an old revision of the document!

---

Introducing Wolfcut Mark Reader

Scope of this manual

Download the latest software

Getting to know the software

Connecting a camera:

1. Connecting a webcam
2. Connecting an IP camera (RTSP)

Calibrating your camera:

1. Make sure your camera is vertical
2. Calibrate your camera

Using the software:

1. Prepare your drawing
2. Open the job in Eding CNC
3. Select the recognition marks
4. Perform the image recognition
5. If a marker isn't found?
6. Send the job for cutting

Troubleshooting

Frequently asked questions