open_job
Open your G-Code file in Eding CNC
Start Eding CNC as normal then load the G-code file from step 1 by clicking on “Auto” (at the bottom of the Eding CNC window), followed by “Load” (the icons at the bottom of the window will change to show this button).
To load a drawing into Eding CNC, press the “Auto” button…
…followed by the “Load” button
When the file is correctly loaded you should see something like this:
If everything looks OK then proceed to the next step.
open_job.txt · Last modified: 2022/08/31 17:49 by wolfcut