camera_vertical
Table of Contents
Camera alignment
For accurate recognition and cutting it is important that the camera is aligned as vertically as possible.
To test the alignment, move the camera over a mark on the table then raise and lower the camera. The mark should remain centered under the camera. If the mark moves away from the center of the camera then the camera should be re-aligned.
Below are examples of bad/good camera alignment.
Example of bad alignment
If the camera is incorrectly mounted, the marks will move away from center when you lower/raise the camera.
Example of good alignment
With corect alignment the marks stay centered when you lower/raise the camera.
camera_vertical.txt · Last modified: 2022/09/22 17:31 by wolfcut