recognize
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| recognize [2022/09/06 03:30] – [Step 2: Adjust the camera contrast] wolfcut | recognize [2022/11/13 19:36] (current) – [Perform the image recognition] wolfcut | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ====== Perform the image recognition ======= | ====== Perform the image recognition ======= | ||
| - | After you select the markers you'll be sent automatically to the "camera" tab. This is where we look for the markers on the table and generate a new G-code file to cut the job at that position. This file will be sent to Eding CNC for cutting. | + | After you select the markers you'll be sent automatically to the "recognizer" tab. This is where we look for the markers on the table and generate a new G-code file to cut the job at that position. This file will be sent to Eding CNC for cutting. |
| The first step is to move the camera over the first marker on the table. | The first step is to move the camera over the first marker on the table. | ||
recognize.txt · Last modified: 2022/11/13 19:36 by wolfcut